3DSWAY 3D Printer Motherboard LERDGE-K ARM 32Bit Controller Board with 3.5" Touch Screen DIY Parts WIFI Control Mainboard
Only K Board:(NO DRIVERS, NO 3.5-INCH TOUCH SCREEN ) If you already have a driver modules, you already have a 3.5-inch touch screen, you can buy Only K Board.
Tip: The Lerdge K motherboard have to match with our 3.5-inch touch screen to be used. The Lerdge K motherboards are not compatible with the touch screen of the old version of the Lerdge S motherboard.
Tip: The Lerdge K motherboard have to match with our 3.5-inch touch screen to be used. The Lerdge K motherboards are not compatible with the touch screen of the old version of the Lerdge S motherboard.
Applicable model:
XYZ(Ultimaker、Makerbot)、Detla、CoreXY(Hbot) and CoreXZ
About power continued to play function:
Lerdge-K motherboard comes with printing pause, printing save, and start-up function. But if you need the function of saving power and continue to play when power off unexpectedly, and the function of automatically turning off after the printing finished, a POWER MODULE is needed.
About printing instructions:
The Lerdge-K motherboard defaults to offline printing (Use TF card printing or U disk printing). If need the online printing, an ONLINE MODULE is needed.
About the use of heated bed:
The heated bed with a power of no more than 150w can be connected directly to the motherboard. If the heated bed power is too large, please use a HIGH POWER MOS HOT BED MODULE
For large-size machines:
If you need to connect externally, please purchase an external drive ADAPTER MODULE to drive a larger motor, such as 57 motor, 86 motor, etc. The motherboard itself is recommended to drive 42 motor. As shown in the figure below.
XYZ(Ultimaker、Makerbot)、Detla、CoreXY(Hbot) and CoreXZ
About power continued to play function:
Lerdge-K motherboard comes with printing pause, printing save, and start-up function. But if you need the function of saving power and continue to play when power off unexpectedly, and the function of automatically turning off after the printing finished, a POWER MODULE is needed.
About printing instructions:
The Lerdge-K motherboard defaults to offline printing (Use TF card printing or U disk printing). If need the online printing, an ONLINE MODULE is needed.
About the use of heated bed:
The heated bed with a power of no more than 150w can be connected directly to the motherboard. If the heated bed power is too large, please use a HIGH POWER MOS HOT BED MODULE
For large-size machines:
If you need to connect externally, please purchase an external drive ADAPTER MODULE to drive a larger motor, such as 57 motor, 86 motor, etc. The motherboard itself is recommended to drive 42 motor. As shown in the figure below.